Sled Maintenance

What grease to use on a snowmobile?

Which grease to use on a snowmobile: a low-temperature, water-resistant grease, plus the OEM options from Polaris, Ski-Doo and Arctic Cat and what to avoid.

On this page
  1. What makes a good snowmobile grease
  2. OEM greases by brand
  3. Aftermarket greases
  4. Where the grease goes
  5. Products that don’t belong on pivots
  6. Switching grease types
  7. Choosing a grease gun
  8. Safety

Use a low-temperature, water-resistant grease on your sled’s suspension and pivots. Synthetic is the better base, and the grease should be rated for sub-zero use. If your owner’s manual names a grease, use that product or one that meets the same spec.

What makes a good snowmobile grease

A sled grease has to work in cold, wet conditions. Look for:

  • Low-temperature performance. Standard automotive chassis grease can stiffen badly in deep cold, to the point that it stops flowing into the joint. Check the rated low temperature on the label.
  • Water resistance. Snow, slush and water wash out ordinary grease. A water-resistant grease stays in the joint longer.
  • Synthetic base. Synthetic greases generally keep their flow better in the cold. Not every synthetic is the same, so check the label.

Most suspension greases are NLGI grade 2. Some low-temperature products are grade 1, which is softer. Use the grade your manual calls for, or one that suits the cold you ride in.

OEM greases by brand

Each manufacturer names its own product:

  • Polaris: Polaris Premium All Season Grease
  • Ski-Doo: XPS Synthetic Suspension Grease
  • Arctic Cat: Arctic Cat Low-Temp Grease

Product names change, so check your owner’s manual. Brand-name OEM grease isn’t required for warranty, but the grease must meet the spec. Warranty rules vary by region, so check with your dealer if you’re unsure.

Aftermarket greases

Aftermarket synthetic low-temperature greases can work well if they meet the spec. Check the rated low temperature and the NLGI grade. Some marine greases resist water well but can stiffen in deep cold, so check the low-temperature rating before you use one on a sled.

Where the grease goes

  • Rear suspension pivot shafts
  • A-arm pivots
  • Spindles
  • Steering post bushings
  • Idler and bearing zerks, where fitted

Clutches aren’t greased. Sheaves, buttons and rollers run dry unless the manufacturer says otherwise.

For the full list of grease points and the routine around them, see the snowmobile maintenance guide to grease points.

Products that don’t belong on pivots

  • Dielectric grease is for electrical connectors and bulb sockets. It isn’t a pivot grease.
  • Anti-seize is for threads and fasteners, not moving joints.
  • WD-40 and spray lubes aren’t grease substitutes for pivots.

Switching grease types

Greases use different thickeners, such as lithium, polyurea or clay. Mixing thickeners can make the grease incompatible. When you switch brands or types, purge the old grease fully before you refill. Keep pumping until the fresh grease comes out and the old grease is gone.

Choosing a grease gun

A cartridge-type grease gun with a flexible hose makes it easier to reach suspension zerks. Choose one that works in cold weather, because stiff seals and cold grease are hard to work with.

Safety

  • Turn the engine off and remove the key and tether before you work on the suspension.
  • Raise and support the sled securely before you grease the rear suspension.

The complete guide to sled maintenance

Snowmobile Maintenance: Grease Points and Service Checklist
Read the guide

Keep exploring

Guides from other topics

All topics →