A carburetor gummed up with varnish is a common reason a carbureted sled starts hard, idles badly or bogs. Stale fuel is the usual cause. Cleaning the carbs fixes most of these problems, as long as you take your time and record the settings before you take anything apart.
Signs the carbs need cleaning
- Hard starting
- Poor idle
- Bogging under throttle
- Surging or flooding
- Problems that start after storage on untreated fuel
Before you clean the carbs, check the basics: fresh fuel, a clean air filter and no fuel or vacuum leaks. See old gas in a snowmobile and how to clean a snowmobile air filter.
Before you take anything apart
Record these before you remove the carburetors:
- Main jet and pilot jet sizes
- Needle clip position
- Float height
- Pilot or air screw setting, counted as turns out from lightly seated
Take photos. Label the fuel, vent and oil lines, and the throttle and choke cables, so you can put everything back where it came from.
Remove the carbs and the float bowl
Remove the carburetors from the intake boots, following the manual. Then remove the float bowl. Inside, you’ll find:
- The float, the float pin, and the float needle and seat
- The main jet
- The pilot jet
- The needle jet
Keep the small parts together and in order.
Clean the jets and passages
Spray the carburetor body and passages with a quality carburetor cleaner. Blow out every passage and jet with compressed air.
The pilot jet is the smallest orifice and the most common clog. Hold it up to the light and confirm you can see through it. Ultrasonic cleaners work well on brass jets, but remove the rubber, plastic and O-rings first.
What not to do to the jets
- Don’t push steel wire or drill bits through jets. They enlarge or scratch the calibrated opening, which changes the jetting. Clear stubborn varnish with a soft wire or a proper tip cleaner, and use gentle pressure.
- Don’t soak whole carbs in a harsh dip. It can destroy seals and floats.
- Don’t expect cleaner in the tank to fix a fully varnished jet. It rarely clears a pilot jet packed with varnish. Clean the carbs directly.
Rebuild parts
Replace the float bowl gasket and the O-rings. If the float needle or seat is worn, replace it too. A rebuild kit for your carb model includes these parts.
Reassembly
- Reinstall the jets, snug. Don’t overtighten brass jets.
- Set the float height to the spec in your manual for your carb model.
- Reinstall the float bowl with its gasket.
- Set the pilot or air screw back to the setting you recorded. Start from the number of turns you wrote down, not a guess.
- Reattach the fuel, vent and oil lines, and the throttle and choke cables. Leave a little free play in the throttle cable.
- Slide the carbs back into the intake boots and tighten the clamps.
- Sync the slides and check the choke.
Oil-injected models
On oil-injected sleds, re-sync the oil pump cable to its alignment marks after carb work. Get this right, because an incorrect setting can affect oil delivery to the engine, causing excess smoke or oil starvation.
Tank additives
Adding carb cleaner to the fuel tank can help with light deposits. It rarely clears a fully varnished pilot jet, so clean the carbs directly when they’re varnished.
Safety
- Carb cleaner and fuel are flammable. Work in a ventilated area with no flames or sparks nearby.
- Wear eye protection and nitrile gloves. Carb cleaner irritates skin.