Carburetor jetting sets the fuel-to-air mix in a carbureted engine. It matters most on older two-strokes, which mostly use Mikuni VM and TM carburetors. A mix that’s too lean can burn a piston quickly. A mix that’s too rich fouls plugs, makes the engine bog and loads up the exhaust.
This article explains how the parts of the tune work together. It isn’t a chart to copy onto your sled. Use your model’s OEM chart.
There’s no universal jetting chart
Jet sizes, and the altitude and temperature steps, depend on the engine, the carburetor, the model year and any modifications. A chart from one sled can be wrong for another. The OEM chart is the safe starting point.
Where to find it:
- The owner’s manual or the service manual
- A decal under the hood, on some models
- Your dealer, if you can give them the model and year
Where to find your model’s stock jet sizes
Most owners want the stock jet sizes first. The sources above are the best place to get them. Forum posts can help you compare, but confirm any numbers against your model’s documentation before you change anything.
Why altitude and temperature change jetting
Air density changes with altitude and temperature.
- Higher altitude. The air is thinner. A carbureted engine usually runs richer up high, so the usual correction is a smaller main jet.
- Colder air. The air is denser, so the engine takes in more oxygen for the same throttle opening. The mix can run leaner, so the usual correction is a larger main jet.
The OEM chart sets how much to change the jet, and at what altitude or temperature steps.
Which circuit controls which part of the throttle
- Pilot jet and air screw: idle to about a quarter throttle
- Needle and needle clip position: about a quarter to three-quarters throttle
- Main jet: three-quarters throttle to wide open
If the sled bogs at part throttle, the problem is usually the needle clip or the pilot circuit. Changing the main jet won’t fix part-throttle bogging.
How main jet numbers work
Mikuni main jets are numbered in steps, such as 380, 390 and 400. A larger number passes more fuel, which richens the mix. Change one step at a time and check the result. Don’t jump several steps at once.
Checking the tune
There are two common ways to check the tune.
Plug reading (plug chop). At wide-open throttle, in a safe and legal place with a clear run, hit the kill switch and coast to a stop. Then read the spark plug. A plug in range usually reads light tan to light brown. Confirm the target colour for your engine in your manual or with a shop, because the reading depends on the engine.
Exhaust gas temperature (EGT) gauge. An EGT gauge gives the most reliable reading. Target EGT ranges vary by engine, so use the figures your manual or the engine builder gives.
Lean versus rich
Lean is not more power. A lean two-stroke at wide open can detonate and burn a piston in seconds. Rich is safer, but it isn’t free. A rich mix fouls plugs, makes the engine bog and loads up the exhaust valves. When you’re unsure, go one step richer rather than leaner.
When jetting isn’t the problem
Changes to the pipes, reeds or ported cylinders change the tune. Those changes need their own jetting, separate from the altitude and temperature corrections.
Check the basics before you blame the jets. Old fuel, a clogged pilot jet and a dirty intake can cause symptoms that look like a jetting problem. See how to clean a snowmobile carburetor, old gas in a snowmobile and how to clean a snowmobile air filter.
Safety
- Gasoline spills around the carburetors. Work with the engine cold and no ignition sources nearby.
- When in doubt, jet one step rich.
- Only change the tune if you’re comfortable doing it. A dealer or a shop that knows two-strokes can check it for you.