Fogging puts a light coat of oil inside the engine, on the cylinder walls, pistons, rings and crankshaft bearings. The point is to slow corrosion while the sled sits for months. Fogging is a precaution. It doesn’t replace fuel stabilizer, and your manual may call for a different storage routine.
Is fogging necessary?
Not every sled needs it, and manufacturers differ. It’s a reasonable step for a two-stroke that will sit through the summer. For a four-stroke, fogging through the spark plug holes is optional and varies by manufacturer. The more important step for a four-stroke is changing the oil and filter before storage. Check your manual before you decide.
Fogging oil and fuel stabilizer do different jobs
Fuel stabilizer keeps gasoline from breaking down in the tank and carburetor. Fogging coats the inside of the engine. Fogging doesn’t replace stabilizer, and stabilizer doesn’t replace fogging. If you fog, you should also stabilize the fuel.
Will WD-40 work as fogging oil?
Use an aerosol fogging oil made for small engines, or the product your manufacturer names. A general-purpose spray lubricant like WD-40 is a different product, and it isn’t a substitute. Regular two-stroke premix oil isn’t a good substitute either.
Order of operations
- Fill the tank with fresh fuel.
- Add fuel stabilizer and mix it in.
- Run the engine for about 5 to 10 minutes, so the treated fuel reaches the carburetors or injection system.
- Fog the engine last.
- Drain the float bowls, or run the carburetors dry, if your manual’s method calls for it.
- Seal the openings and put the sled away.
Carbureted two-strokes: the throat method
On a carbureted two-stroke, remove the intake silencer. With the engine at fast idle, spray into each carburetor throat until you see heavy smoke or the engine stalls. Keep your hands and clothing clear of the clutch while the engine runs with its covers off.
The spark plug method
Use this method when your manual calls for it, or on engines where the throat method isn’t practical.
- Remove the spark plugs.
- Spray a short burst into each cylinder, about two to three seconds’ worth. Follow the product label.
- Ground the plug wires, or disconnect them, before you turn the engine over.
- Turn the engine over several times with the starter or by hand.
- Reinstall the plugs.
Fuel-injected two-strokes and E-TEC
Fuel-injected two-strokes differ. Many manufacturers specify fogging through the spark plug holes rather than the throttle bodies. Ski-Doo E-TEC engines have a built-in storage procedure that uses the engine’s own oil system, and the steps vary by model year. Follow the manual for your engine.
Four-strokes
Change the oil and filter before storage. Fogging is optional and varies by manufacturer, so check the manual. See how often to change snowmobile oil for the oil side.
Carbureted sleds: float bowls
After fogging, either drain the float bowls or run the carburetors dry. The method varies by owner and manual. Draining the bowls removes fuel that could varnish over the summer. If the bowls have varnished anyway, see how to clean a snowmobile carburetor.
Sealing the engine
Plug the exhaust outlet and the intake to keep out moisture and mice. Note the plugs, so you remember to remove them before you start the engine in spring.
Should you start the engine after fogging?
Not during storage. Starting the engine during the summer undoes the fogging and can cause condensation inside the engine. The run in step 3 is the one before fogging. It circulates the stabilizer through the fuel system. It isn’t a start-up after fogging.
What to expect in spring
The first start after fogging often produces heavy smoke. Plugs can foul, especially if you used too much fogging oil. Carry spare plugs. Remove the exhaust and intake plugs before you start the engine. More fogging oil doesn’t give better protection, and the excess can pool and foul the plugs.
Safety
- Fogging oil and its smoke are flammable. Fog outdoors, or in a space with strong ventilation, with no open flames or pilot lights nearby.
- Keep hands and clothing clear of the clutch while the engine runs with its covers off.