Sled Maintenance

How Often to Change Snowmobile Oil and Which Oil to Use

How often to change snowmobile oil: two-strokes just keep the injection tank full, four-strokes need regular oil and filter changes, and the right oil.

On this page
  1. Two-stroke sleds: keep the tank full
  2. Four-stroke sleds: change the oil and filter
  3. Why change it even if you don’t ride much
  4. Which oil to use
  5. Why sled-specific oil matters
  6. Checking the oil level
  7. What not to use
  8. Chaincase oil on the same schedule
  9. Before storage
  10. Safety

How often you change snowmobile oil depends on the engine type. Two-strokes have no crankcase oil to change. Four-strokes do, and they need regular oil and filter changes. Your manual sets the interval. This article explains the difference and which oil fits each engine type.

Two-stroke sleds: keep the tank full

On an oil-injected two-stroke, oil comes from a separate tank and is burned with the fuel. There’s no crankcase oil to drain. Your job is to keep the injection tank filled. If the tank oil is contaminated, you can drain and refill it, but there’s no routine change.

Four-stroke sleds: change the oil and filter

Four-strokes need an oil and filter change on the interval in your manual.

  • The first change often comes early, after break-in. Check your manual for the timing.
  • After that, change the oil at the manufacturer’s interval, and at least once a year.
  • Change four-stroke oil before summer storage, so acids and moisture don’t sit in the engine all summer.

Why change it even if you don’t ride much

Low-mileage sleds still need a yearly change. Condensation builds up in the engine over time, including during storage, whatever the odometer says. Mileage alone isn’t a good guide.

Which oil to use

Use the oil your manufacturer names for your model, and verify it in the manual. Examples:

  • Ski-Doo ACE and 4-TEC four-strokes: XPS 4-Stroke Synthetic 0W-40 (verify per model)
  • Arctic Cat and Yamaha four-strokes: Arctic Cat ACT or Yamalube 0W-30 or 0W-40 (verify per model)
  • Polaris two-strokes: a Polaris VES-family full synthetic two-cycle oil. See what kind of oil does a Polaris snowmobile take.
  • Ski-Doo two-strokes: XPS Synthetic 2-Stroke. E-TEC engines use their own spec.

Why sled-specific oil matters

Two-stroke oil has to flow in sub-zero temperatures, and sled oils are formulated for that. Four-strokes need a 0W grade for reliable cold starts. Car oil isn’t automatically the same. Use the oil your manual specifies.

Checking the oil level

Check the level the way your manual describes. Procedures vary. Some dry-sump four-strokes are checked after the engine has idled warm. Don’t guess. Follow the manual.

What not to use

  • TC-W3 outboard oil. It isn’t approved for snowmobile oil injection.
  • Car oil in a two-stroke tank. It doesn’t belong there.

Chaincase oil on the same schedule

Change the chaincase or gearcase oil once a year too. For the steps, see how to change snowmobile gearcase oil.

Before storage

Before you store a four-stroke for the summer, change the oil and filter. Fog the engine if your manufacturer recommends it. See how to fog a snowmobile engine.

Safety

Oil and exhaust parts get very hot. Let the engine cool before you drain the oil.

The complete guide to sled maintenance

Snowmobile Maintenance: Grease Points and Service Checklist
Read the guide

Keep exploring

Guides from other topics

All topics →