The right cold-start steps depend on whether the sled is carbureted or fuel-injected, and on how cold it is. The most common cold-start mistakes are too much choke and too much throttle. Free the track and check the battery first, then follow the start method for your sled.
Free the track and check the battery
A track frozen to the snow or a hard-packed trail can load the engine when you throttle. Lift the rear of the sled and drop it, or rock it, to break the track free before you start. Throttling against a frozen track can burn a belt in seconds.
Cold weather also drains lead-acid batteries. Commonly cited figures put the loss at about a third of capacity at 32 °F and more than half at 0 °F. Keep the battery on a 1 to 2 amp smart maintainer, since a fully charged battery resists freezing. Engine or battery heaters and indoor parking help below zero. If the battery won’t hold a charge, see why a snowmobile battery isn’t charging.
Carbureted sleds: choke and enricher
Use the choke, or the enricher, with the throttle closed. Ease the choke off as the engine warms. The enricher only works with a closed throttle, so opening the throttle defeats it.
Some carbureted sleds have a primer. In deep cold, two to four pumps is a common starting point, and more can flood the engine. Check the manual for your model.
Fuel-injected sleds
EFI sleds don’t use a choke. Leave the throttle alone unless the manual says otherwise. On battery-less EFI sleds, a brisk, full-length pull powers the engine control unit and fuel pump, so a slow pull may not start the engine. Snowmobile hard to pull start covers the pull technique.
Warm up gently
Let the engine idle for about 2 to 5 minutes, or until the temperature gauge rises. The right time varies by model. Avoid high rpm while the engine is cold. Aluminum pistons expand faster than the cylinders around them, so a cold engine run hard can scuff. Long idles of 15 to 20 minutes aren’t better, since they can foul the plugs.
Use the right oil
Use 2-stroke oil rated for low temperatures. Four-stroke sleds commonly use 0W-40 synthetic, but check the owner’s manual for the approved spec. Our guide to snowmobile oil changes and oil types covers both engine types.
If it still won’t start
If the engine cranks but won’t fire, the sled may be flooded. Clearing a flooded snowmobile engine covers the steps. If the engine won’t crank at all, check the battery, then work through why a snowmobile won’t start.
Mistakes to avoid
- Pumping the throttle helps a cold start. It doesn’t help, and on EFI sleds you should leave the throttle alone.
- Long idle warm-ups are better. They foul plugs.
- Revving a cold engine warms it safely. High rpm on a cold engine risks scuffing.
- Starting fluid is a good 2-stroke cold-start aid. It strips lubrication, so avoid it.
Safety
- Never warm up a sled in a closed garage. Exhaust contains carbon monoxide.
- Check that the throttle returns freely. Ice can stick it open.