Most modern snowmobiles are liquid-cooled. An engine-driven water pump moves coolant through the engine to aluminum heat exchangers in the tunnel, and the snow thrown up by the track cools them. Fan-cooled sleds, found on some utility and entry models, use a belt-driven fan and a shroud instead. Older sleds were often free-air cooled.
The liquid-cooling system
- Water pump. Circulates the coolant, a mix of antifreeze and water, through the cylinders and cylinder heads.
- Thermostat. Stays closed during a cold start so the engine warms up quickly, then opens as the engine reaches temperature.
- Heat exchangers. Long aluminum tubes or fins along the tunnel, and often the front bulkhead. They move heat from the coolant to the snow and air.
- Coolant reservoir. Holds extra coolant and lets it expand and contract safely.
Liquid-cooled sleds usually have no radiator fan, so they don’t look like a car. The heat exchangers do the work that a car’s radiator and fan do.
Why snow matters
The heat exchangers only work when snow reaches them. Snow thrown by the track and ice scratchers lands on them and carries heat away. On hardpack, ice or low snow, little snow reaches the heat exchangers and temperatures rise. A liquid-cooled sled can also overheat if it idles in one spot without any snow spray. This is why a sled can run cool in powder and overheat on a bare trail.
Fan-cooled sleds
Fan-cooled engines use an engine-driven fan and finned cylinders inside a shroud. A broken or loose fan belt, or a clogged shroud, can cut airflow and cause overheating. These sleds don’t rely on snow contact the same way liquid-cooled sleds do.
Coolant and bleeding
Typical coolant is a 50/50 mix of ethylene glycol and water, which protects to about -34 °F (-37 °C). Follow the manufacturer’s spec. Plain water isn’t a winter coolant.
Air pockets reduce cooling. When you refill the system, bleed it according to the manual, which often means raising the front of the sled. Snowmobile overheating causes and fixes covers what happens when air or low coolant gets into the system.
Other cooling areas
- Slides. Hyfax slides also rely on snow for cooling and can melt on bare ice.
- CVT belt. The drive belt is air-cooled through vents in the clutch cover. It’s separate from the engine’s cooling system.
Warning signs
Most sleds have an overheat warning light or a limp mode, and the thresholds vary by model. If the warning comes on, slow down, find loose snow, or stop and let the engine cool. A coolant leak can also cause white smoke from the exhaust.
Mistakes to avoid
- Snowmobiles have car-style radiators with fans. Most liquid-cooled sleds don’t.
- Cold air alone keeps a sled cool. The heat exchangers need snow contact.
- Plain water is fine as winter coolant. Use the manufacturer’s mix.
- Riding faster on hardpack cools the engine. Speed alone doesn’t bring snow to the heat exchangers.
Safety
Never open the coolant cap when the engine is hot.