Engine Troubleshooting

What does gearing down a snowmobile do?

Gearing down a snowmobile trades top speed for more track torque and quicker acceleration in deep snow. Learn how gear ratio works and what to retune.

On this page
  1. How gearing is set
  2. What changes on the trail
  3. The trade-off
  4. Retune the clutching
  5. Where riders disagree
  6. Mistakes to avoid
  7. Safety

Gearing down a snowmobile gives you more torque at the track, quicker acceleration and better pulling in deep snow. The trade-off is top speed. Lower gearing also helps the engine stay in its powerband under load, which can reduce bogging. Changing the gears changes how the clutches shift, so the setup needs to be retuned afterward.

How gearing is set

Gearing is set by the top (drive) and bottom (driven) sprockets in the chaincase or gearcase. The ratio is bottom teeth divided by top teeth. A higher number means lower gearing. Gearing down means fewer top teeth or more bottom teeth.

Moving one tooth changes the ratio only a little. The speed gained or lost per tooth varies with the ratio, the track and the sprocket size.

What changes on the trail

  • More torque at the track, which helps in deep snow, on climbs and when towing.
  • Quicker acceleration.
  • Less belt load, heat and slip in slow, high-load riding.
  • A better match for the powerband, so the engine is less likely to bog under load.

Mountain sleds are usually geared lower than trail or lake sleds.

The trade-off

Lower gearing lowers top speed. If you ride a lot of open trail at high speed, a lower gear may feel too restrictive.

Retune the clutching

Changing the gearing changes how the clutches shift, so check the clutching after any gearing change. Chain length can change with a sprocket change, and the chain tension should be set per the manual. Refill the chaincase with the specified oil afterward.

Where riders disagree

Riders and tuners disagree about the best ratio for a given track and snow type. Some advise gearing as high as you can before you lose acceleration. Others prefer lower gears for deep snow. Test one change at a time, and note how the sled behaves in the conditions you ride in.

Mistakes to avoid

  • Gearing down adds horsepower. It changes how the engine is loaded. It doesn’t add power.
  • Gearing fixes clutching problems on its own. Clutch tuning still matters.
  • Lower gearing always helps on the trail. It cuts top speed and can make the sled feel different on open trail.
  • A one-sprocket change never needs a new chain. Check the chain length.

Safety

Remove the tether before you open the chaincase.

The complete guide to engine troubleshooting

Snowmobile Won't Start: A Step-by-Step Troubleshooting Guide
Read the guide

Keep exploring

Guides from other topics

All topics →