Engine Troubleshooting

What are the symptoms of an ignition coil failure in a snowmobile?

A failing ignition coil on a snowmobile shows as weak or missing spark, misfires under load and cutting out when hot. Learn the symptoms and how to confirm it.

On this page
  1. What a failing coil looks like
  2. Power loss and twin sleds
  3. Look for visible damage
  4. Confirm the coil
  5. Rule out other parts first
  6. Mistakes to avoid
  7. Safety

An ignition coil failure usually shows up as weak or missing spark, misfires under load or at high rpm, and a sled that cuts out when hot and restarts after it cools. Hard starting, popping or backfiring, and cutting out in wet weather are also common signs. Many of these symptoms can come from plugs, plug caps, the kill switch or the CDI, so confirm the coil before you replace it.

What a failing coil looks like

  • No spark, or a weak, thin orange spark instead of a strong blue-white one.
  • Misfiring or cutting out under load or at high rpm.
  • Running fine when cold, then cutting out when hot. It restarts after cooling.
  • Cutting out when wet, or after washing the sled. This can point to a cracked case or boots.
  • Hard starting, especially when cold.
  • Popping or backfiring from an intermittent misfire.

The hot-then-restart pattern is the one to watch. A sled that runs then dies covers other heat-related causes too.

Power loss and twin sleds

Power loss, or running on one cylinder, can happen on twins with separate coils. Many 2-stroke twins use one dual-output coil, so a failure usually kills both cylinders. A dead cylinder doesn’t always mean a bad coil, though. Check the plug, the plug cap and the wiring for that cylinder first.

Look for visible damage

Cracked casing, burn marks, carbon tracking and corroded terminals are signs of a coil that needs replacing.

Confirm the coil

  • Resistance. Primary and secondary readings are specific to each model, so use the service manual. A reading in spec doesn’t prove the coil is good.
  • Plug caps. Many plug caps contain a resistor. A bad cap can look like a bad coil.
  • Heat test. A coil can test good cold and fail hot. Swapping in a known-good coil is often the clearest test.

Rule out other parts first

Check the kill switch, the plugs, the plug caps, the CDI and the stator before you replace the coil. What causes a snowmobile to lose spark lays out the full order, and a sled that won’t start covers the no-start case.

Mistakes to avoid

  • Every misfire means a bad coil. Fouled plugs and fuel problems cause misfires too.
  • A good ohmmeter reading proves the coil is fine. It doesn’t test the coil under heat.
  • A dead cylinder always means a bad coil. Check the plug, cap and wiring first.
  • Coils only fail completely. Many fail intermittently, which is why the symptoms come and go.

Safety

  • Hold wires with insulated pliers. Coil output can shock.
  • Don’t spark-test near fuel vapor.

The complete guide to engine troubleshooting

Snowmobile Won't Start: A Step-by-Step Troubleshooting Guide
Read the guide

Keep exploring

Guides from other topics

All topics →