Engine Troubleshooting

Snowmobile Battery Not Charging: Stator and Regulator Checks

A snowmobile battery that won't charge usually points to the stator, regulator or wiring. Learn the expected voltages and the checks to run first.

On this page
  1. How the charging system works
  2. Read the battery first
  3. Check the charging voltage at running speed
  4. Check the easy things first
  5. Test the stator
  6. Test the regulator/rectifier
  7. Loads and storage drain
  8. Mistakes to avoid
  9. Safety

A snowmobile battery that won’t charge usually points to the stator, the regulator or rectifier, or the wiring between them. Before you replace parts, measure the battery and the charging voltage, then check the stator and the regulator in order.

How the charging system works

Charging starts at the stator, which sits under the flywheel and makes AC. The regulator/rectifier converts that to DC and holds the voltage in range. The battery stores the DC. A fault anywhere along this path can leave the battery low.

Read the battery first

Battery voltage at rest tells you the state of charge:

  • 12.6 to 12.8 volts: fully charged.
  • About 12.4 volts: roughly 75 percent charged.
  • About 12.0 volts or less: discharged.

A battery that rests low may just need charging. One that won’t hold a charge after a full charge may be failing.

Check the charging voltage at running speed

With the engine running, measure the voltage at the battery. Expect about 13.5 to 14.5 volts at 3,000 rpm or more. The exact figure varies by model, so check the spec for your sled.

  • Under about 13 volts while running means undercharging.
  • Over about 15 volts means the regulator is overcharging.

Many sleds charge weakly at idle, and short rides with electric starts can drain the battery over time.

Check the easy things first

Look at the fuses, the battery terminals, the cables and the grounds. Melted stator connectors are a common failure point, so inspect them too.

Test the stator

  • Resistance. Unplug the stator leads and measure between each pair of legs. The readings should be low and even. The spec varies by model.
  • Ground test. There should be no continuity from any stator lead to ground.
  • AC output. The AC voltage between the leads should rise with rpm. The spec varies by model.

The stator also powers the ignition on battery-less sleds, so a stator fault can show up as a loss of spark too.

Test the regulator/rectifier

Check the regulator with a diode test, or swap in a known-good unit. Heat and bad grounds are the usual causes of regulator failure.

Loads and storage drain

  • Heated grips, visors and GPS can draw more power than the stator makes at low rpm.
  • Parasitic draw drains a battery in storage. Use a 1 to 2 amp smart maintainer, and use the AGM setting for an AGM battery.
  • Some sleds run the headlights from a separate AC lighting coil. A working headlight doesn’t prove the charging system is fine.

Cold weather makes all of this worse, so keep the battery charged and warm the sled before starting in deep cold.

Mistakes to avoid

  • A working headlight proves the charging system is fine. The lights may run from a separate coil.
  • A new battery fixes a charging problem. It only replaces the storage. The charge source still needs checking.
  • Idling recharges a dead battery. Idling charges weakly at best.
  • Any automotive charger is fine for a sled battery. Use a charger that suits your battery type.

Safety

  • Charge in a ventilated area. Batteries vent hydrogen.
  • Disconnect the negative terminal first.

The complete guide to engine troubleshooting

Snowmobile Won't Start: A Step-by-Step Troubleshooting Guide
Read the guide

Keep exploring

Guides from other topics

All topics →