Engine Troubleshooting

What are the symptoms of a bad fuel pump on a snowmobile?

A bad fuel pump on a snowmobile shows up as bogging under load, lean surge at wide-open throttle, hard starts or a missing prime hum. Here's how to tell.

On this page
  1. Two types of fuel pump
  2. Symptoms on carbureted sleds
  3. Symptoms on EFI sleds
  4. Check the easy causes first
  5. Test the pulse pump
  6. Mistakes to avoid
  7. Safety

A failing fuel pump on a snowmobile usually shows up as bogging or stumbling under load, a lean surge or power loss at wide-open throttle, and hard starting. On electric fuel-injected sleds, a missing prime hum at key-on is another clue. Many of these symptoms also come from a clogged filter or a restricted line, so check those first.

Two types of fuel pump

Snowmobiles use two kinds of pump:

  • Crankcase pulse-driven diaphragm pumps on carbureted sleds. Crankcase pressure pulses drive a diaphragm that pushes fuel toward the carburetor.
  • Electric in-tank pumps on EFI sleds. An electric motor drives the pump, and the engine control system manages fuel pressure.

The symptoms differ a little between the two.

Symptoms on carbureted sleds

  • Bogging, stumbling or cutting out at high rpm or under load.
  • Lean surge or power loss at wide-open throttle.
  • Hard starting, or starting and then dying once the float bowls empty.

Pulse pump diaphragms can stiffen or tear with age and with ethanol fuel, and rebuild kits are common. Bogging under load has a few other causes, so check the list before you replace the pump.

Symptoms on EFI sleds

  • No prime hum for a few seconds at key-on, on electric-start models.
  • A whining pump, low fuel pressure codes, or the check-engine light.

Pressure specs vary by model. Many EFI sleds run roughly in the 40 to 60 psi range, but test against the manual’s figure with a gauge at the test port.

Check the easy causes first

Before you blame the pump, rule out the tank vent, the filter, the pickup and any kinked lines. A cracked pulse line on a carbureted sled can mimic a bad pulse pump. On battery-less EFI sleds, a weak stator can look like a pump failure too. A sled that runs then dies covers the vent and filter checks in more detail.

Test the pulse pump

On a carbureted sled, disconnect the pump’s outlet line and point it into a container. Crank the engine. Steady spurts of fuel mean the pump is working. Weak or irregular output points to a pump fault or a restriction upstream.

Mistakes to avoid

  • Fuel starvation always means a bad pump. Filters, vents and lines cause many of the same symptoms.
  • Carbureted sleds use electric pumps. Most carbureted sleds use a pulse-driven diaphragm pump.
  • A pump that primes delivers full pressure under load. A pump can prime fine and still fail under load.
  • It’s fine to keep riding with a mild bog. Lean running can burn pistons, so stop and fix it.

Safety

  • Relieve fuel pressure on EFI sleds before you open any fuel line.
  • Work with fuel in a ventilated area, away from ignition sources.

The complete guide to engine troubleshooting

Snowmobile Won't Start: A Step-by-Step Troubleshooting Guide
Read the guide

Keep exploring

Guides from other topics

All topics →