Engine Troubleshooting

Flooded Snowmobile Engine: How to Clear It and Start Again

A flooded snowmobile smells of fuel and won't fire. Learn how to clear a flooded carbureted or EFI engine, what causes it, and when to replace the plugs.

On this page
  1. Signs of a flooded engine
  2. What causes flooding
  3. Clear a carbureted engine
  4. Clear an EFI engine
  5. After the engine starts
  6. Prevention
  7. Mistakes to avoid
  8. Safety

A flooded snowmobile engine has too much fuel in the cylinders to fire. It smells of gas, may give a brief pop or no fire at all, and the spark plugs come out wet. The fix is to clear the excess fuel, dry or replace the plugs, and restart with the choke off. If the engine won’t crank at all, check why a snowmobile won’t start first.

Signs of a flooded engine

  • A strong fuel smell.
  • No fire, or a brief fire that dies.
  • Wet, fuel-soaked spark plugs.
  • Fuel dripping from the airbox drains.

What causes flooding

  • Too much choke or priming.
  • Repeated short start-stop cycles before the engine warms up.
  • A stuck carburetor float needle.
  • A leaking float needle with fuel on during storage or transport. This can even fill the crankcase.

Clear a carbureted engine

Two methods work.

  1. Throttle open, choke off. Turn the choke off, hold the throttle wide open, and pull or crank the engine several times. This clears the excess fuel.
  2. Plugs out. Remove the spark plugs and crank the engine several times to expel the fuel. Dry the plugs or replace them, then reinstall. Ground the plug wires while you crank with the plugs out.

Fuel-fouled plugs often won’t recover, so carry spares and a plug wrench. Waiting 15 to 30 minutes lets some fuel evaporate, and this works better in milder temperatures.

Clear an EFI engine

Many EFI systems enter a clear-flood mode when you crank with the throttle held wide open. The behavior varies by manufacturer, so check the owner’s manual before you try it.

After the engine starts

  • Expect heavy smoke and a rough idle at first.
  • Keep rpm low until the smoke clears.
  • On a 4-stroke, fuel can dilute the oil. If the oil level has risen, or the oil smells of fuel, change it.

If fuel runs out of the carburetor overflow, the float needle may be stuck. Clean or replace the needle and seat as part of a carburetor cleaning. Heavy smoke after a flood is usually fuel, not coolant. White smoke from snowmobile exhaust explains how to tell them apart.

Prevention

Mistakes to avoid

  • More choke or priming helps a flooded engine. It makes it worse.
  • Pumping the throttle clears flooding on EFI sleds. Use the clear-flood procedure instead.
  • Starting fluid fixes a flooded 2-stroke. It doesn’t, and it strips lubrication.
  • Only old carbureted sleds flood. EFI sleds can flood too.

Safety

  • Ground plug wires when you crank with the plugs out.
  • Ventilate the area. Keep flames and smoking away.
  • Wipe up spilled fuel before you restart.

The complete guide to engine troubleshooting

Snowmobile Won't Start: A Step-by-Step Troubleshooting Guide
Read the guide

Keep exploring

Guides from other topics

All topics →