Sled Maintenance

How tight should my belt be on my snowmobile?

How tight a snowmobile drive belt should be: why tension is set by deflection or belt height rather than feel, and how too-tight and too-loose belts show up.

On this page
  1. How belt tension is set
  2. How to check deflection
  3. How the adjustment is made
  4. Signs the belt is too tight
  5. Signs the belt is too loose
  6. Recheck after break-in
  7. Aftermarket belts
  8. When the spec can’t be reached
  9. Track tension is a separate adjustment
  10. Safety

A snowmobile drive belt isn’t tightened by feel. The driven clutch sets the belt position, and the spec is either a deflection measurement or a belt height. Both are in your manual. Set the belt to that spec. A belt that’s too tight and one that’s too loose both cause problems.

How belt tension is set

Two methods are common:

  • Deflection. You measure how far the belt sags under a set force, at a point midway between the clutches. The manual gives the spec and the force.
  • Belt height. On many Ski-Doo driven clutches, the top of the belt sits flush with, or just above, the edge of the driven sheave. Use the spec and the tool the manufacturer names.

Specs vary by model. Use the figure for your sled, not one from another model or a forum post.

How to check deflection

  1. Park on level ground with the engine off, and remove the key and tether.
  2. Clean the sheaves first. A belt can measure in spec when cold and still slip if the sheaves are dirty or worn.
  3. Lay a straightedge across the belt, midway between the clutches.
  4. Push down on the belt with the force your manual specifies.
  5. Measure how far the belt drops below the straightedge, and compare the reading with the spec.

How the adjustment is made

Adjustment methods depend on the clutch:

  • Shims or spacers between the driven sheaves, on older sleds
  • Set screws or bolts on the driven clutch, on most modern sleds

Adjust all the screws evenly, the same amount on each, so the sheaves stay square. Turn the clutch by hand to seat the belt, then measure again. Repeat until the reading is in spec.

Signs the belt is too tight

  • The sled creeps or lurches at idle
  • Harder starting
  • The belt drags when the engine is warm

Signs the belt is too loose

Recheck after break-in

Belts wear narrower and ride lower in the driven clutch over time. A belt that’s in spec when new can drift out of spec after break-in. Check the deflection again after break-in and at the start of each season.

Aftermarket belts

An aftermarket belt may need its deflection reset when you fit it. Length and width must match the OEM part for your model. A belt of the wrong size may not be able to reach spec.

When the spec can’t be reached

If you can’t get the belt into spec, check:

  • The clutch center distance
  • The clutch offset
  • The sheaves, for dirt or wear

The belt and clutches work together. A belt that won’t adjust often points to a clutch problem.

Track tension is a separate adjustment

Adjusting the track tension doesn’t change the belt tension. They’re separate adjustments with separate specs.

Safety

Turn the engine off and remove the key and tether before you touch the clutches. Keep hands and clothing clear of the belt and clutch while the engine is running.

The complete guide to sled maintenance

Snowmobile Maintenance: Grease Points and Service Checklist
Read the guide

Keep exploring

Guides from other topics

All topics →