Tracks and Suspension

How to Adjust Snowmobile Track Tension

How to adjust snowmobile track tension: lift the rear, turn both adjusters evenly, measure against your manual, set alignment, and recheck after break-in.

On this page
  1. What you need
  2. Step 1: Raise the rear
  3. Step 2: Loosen the axle and jam nuts
  4. Step 3: Turn both adjusters the same number of turns
  5. Step 4: Measure tension
  6. Step 5: Set alignment
  7. Step 6: Retorque
  8. Break-in: new tracks stretch
  9. Too tight vs too loose
  10. Common myths
  11. Safety

Track tension and alignment are set with the rear raised, and they go in order: tension first, then alignment. Turn the adjusters evenly, and follow the tension spec in your owner’s manual. The manual’s figure overrides any figure you find online.

What you need

  • A socket set and wrenches sized for your model, often 10 mm and 15 or 17 mm
  • A flat-head screwdriver for the idler wheel caps, on models that have them
  • A tape measure
  • A tension gauge or scale, if your manual calls for one
  • Your owner’s manual

Step 1: Raise the rear

Raise the rear on a stand or hoist so the track hangs free. Make sure the track is cool and clear of ice before you measure, so the reading is consistent.

Step 2: Loosen the axle and jam nuts

Loosen the rear idler axle bolts and the adjuster jam nuts. Loosen them, but do not remove them. The adjusters need to move freely for the next step.

Step 3: Turn both adjusters the same number of turns

Turn both adjusters the same number of turns. Turning them in tightens the track. Keep the two sides matched, and note the number of turns on each side as you go, so the track stays square.

Step 4: Measure tension

Check the tension spec for your model. Methods differ by brand:

  • Polaris commonly uses 10 lb of force applied about 16 in. ahead of the rear idler shaft.
  • Ski-Doo uses a tension gauge at mid-span.
  • Other brands: follow the manual.

Apply the specified force near the middle of the slide rail, and measure the gap between the hyfax and the track or clips. Typical deflection on many trail sleds is about 3/4 to 1-1/4 in. Mountain sleds often run looser. Figures found online vary and sometimes describe a different gap, so the manual’s spec wins.

Step 5: Set alignment

With the tension set, run the track slowly by hand or on the stand. Check the clip-to-rail gap on both sides. The gaps should match. If the track runs toward one side, turn one adjuster in small steps, then recheck. The manual shows which direction to turn for your model. Small steps matter, because a large change can throw the tension off.

Step 6: Retorque

Retorque the axle bolts and jam nuts to the manual’s spec. Recheck tension and alignment afterward, since the setting can shift when the bolts are tightened.

Break-in: new tracks stretch

New tracks stretch during the first rides. Ride moderately at first, then recheck tension after roughly the first 50 miles. Keep checking as the track settles.

Too tight vs too loose

  • Too tight adds drag, lowers top speed, adds heat, and wears the hyfax and bearings.
  • Too loose can cause ratcheting under load, let the track strike the tunnel or heat exchanger, and can lead to derailing.

For the hyfax that a tight track wears, see snowmobile hyfax: when and how to replace slide rails.

Common myths

  • “Tighter is better.” Too tight wears parts and costs speed.
  • “You can check tension with the sled on the ground.” Check with the rear raised.
  • “Tension and alignment do not affect each other.” They do, which is why tension comes first.
  • “All sleds use the same spec.” Specs vary by brand and model.

Safety

When you spin a lifted track, do it slowly. Stand to the side, and keep your hands and clothing clear of the track and drive.

If the track is worn or ratcheting, check the track itself before you adjust it again. See when to replace a snowmobile track. For the job of putting a new track on, see how to install a snowmobile track, step by step. For the wider picture, see snowmobile tracks and rear suspension explained.

The complete guide to tracks and suspension

Snowmobile Tracks and Rear Suspension Explained
Read the guide

Keep exploring

Guides from other topics

All topics →