Sled Maintenance

How to Clean a Snowmobile Air Filter

How to clean a snowmobile air filter: washing and drying foam pre-filters, when paper elements get replaced, and what a clogged or iced intake does.

On this page
  1. Identify your filter
  2. Clean a foam pre-filter
  3. Should you oil the filter?
  4. Paper elements
  5. Check the airbox and the seal
  6. Protecting the intake from snow
  7. How often to clean it
  8. What a clogged or iced filter does
  9. Common mistakes
  10. Safety

A snowmobile’s intake filter keeps snow, dust and debris out of the engine. A dirty or iced filter starves the engine of clean air, which can make it run rich, bog and lose power. Cleaning the filter is a quick job, but first find out what kind of filter your sled has.

Identify your filter

Many sleds have no car-style paper filter. The intake uses an airbox or silencer with one of these:

  • A foam pre-filter, which can be washed and reused
  • A screen
  • A paper element, on some four-strokes, which should be replaced, not washed

Your manual shows which one you have.

Clean a foam pre-filter

  1. Turn the engine off. Remove the filter from the airbox, following the manual.
  2. Wash it in warm water with mild dish soap or a foam filter cleaner.
  3. Rinse until the water runs clear.
  4. Squeeze the water out gently. Don’t wring or twist the foam, because that tears it.
  5. Let it dry fully at room temperature before you reinstall it.

Don’t use a heat gun or a dryer. Don’t use gasoline or harsh solvents, since they degrade foam.

Should you oil the filter?

Most OEM sled foam pre-filters are used dry, without oil. Oil the filter only if the manufacturer specifies it. Oiling a dry-type filter can attract snow and restrict airflow.

Paper elements

Replace paper elements rather than washing them. Washing damages the paper.

Check the airbox and the seal

Inspect the airbox for packed snow, ice, water and rodent nests, especially after storage. Check that the filter seats properly. A gap around the filter lets unfiltered air and snow reach the engine.

Protecting the intake from snow

Water-repellent pre-filter covers fit over the intake and help keep snow out. They don’t replace cleaning or inspection.

Don’t remove the pre-filter for more power. It lets snow into the intake, which can stall the engine.

How often to clean it

Inspect the filter every season, and after riding in heavy snow or dust. Clean it when it’s dirty or clogged.

What a clogged or iced filter does

A clogged or iced filter restricts airflow. The engine runs rich, bogs and loses power. If the problem continues after you clean the filter, check the carburetor. See how to clean a snowmobile carburetor.

Common mistakes

  • Using gasoline or harsh solvents on foam
  • Oiling a filter the manufacturer says to run dry
  • Using high-pressure compressed air, which can tear foam
  • Removing the pre-filter for more power

Safety

Turn the engine off when the intake is open. Never run the engine without the intake installed.

The complete guide to sled maintenance

Snowmobile Maintenance: Grease Points and Service Checklist
Read the guide

Keep exploring

Guides from other topics

All topics →