Why every sled needs at least two straps
A sled that is not tied down can shift forward, back, or side to side. That movement can damage the sled, the trailer, and the truck. Use at least two straps per sled, one at the front and one at the rear. Heavy or long loads may need more.
The front tie-down
- Run the front strap from the trailer’s front D-ring to the ski loops, the ski spindles, or a ski bar.
- Pull the sled forward against the stops.
- Add a ski chock, ski tie-down, or ski lock to stop the skis from sliding side to side.
- Do not hook straps to the ski tips. Many ski tips are not designed as strap points.
The rear tie-down
- Run the rear strap over or through the rear bumper, or use the tunnel strap points, and attach it to the trailer’s rear D-rings.
- Pull the strap down and slightly back.
- Snug it enough that the sled does not bounce, but do not compress the rear suspension hard.
- A rear track clamp is an alternative to straps at the back. It holds the track in place.
Choosing straps
- Ratchet straps are the usual choice. Use ones that are 1 to 2 in wide, with the working load limit (WLL) marked on the label.
- The WLL is not the break strength. It is usually about one-third of the break strength. Use the marked WLL when you plan your load.
- A common rule of thumb comes from commercial cargo rules. The combined WLL of all your straps should be at least half the weight of the cargo. Treat it as good practice for personal hauling.
- Cam buckle straps have lower ratings and suit light-duty backup use.
- Rope and bungee cords are not suitable as primary tie-downs. They stretch and can fail.
- Replace straps that are frayed, cut, or faded by UV.
Protecting the sled
- Use soft loops around the ski spindles or other metal parts. They protect paint and plastic.
- Avoid strapping over the seat, hood, windshield, or handlebars. A strap over the seat can tear the upholstery and does not stop the sled from rotating and shifting. One strap over the seat is not enough.
- On an open trailer, remove the windshield or use a trailerable cover. Pull the tether key.
Tension: snug, not crushing
Tighten the straps enough to stop movement, but not so far that you crush the suspension or crack plastic. Compressing the rear suspension slightly is the goal. Keep your hands clear of the ratchet when you release it under tension.
Re-check the straps
- Re-check after the first 10 to 25 miles, because straps loosen as the load settles.
- Check again at each fuel stop.
- Tuck or tie off loose strap ends so they do not flap and wear.
Common mistakes
- “One strap over the seat is enough.” It is not. The sled can still rotate and shift.
- “Tighter is always better.” Over-tightening crushes the suspension and can crack plastic.
- “Hooks on the skis are fine.” Many ski tips are not strap points. Use ski loops or spindles.
- “Cam buckles are the same as ratchets.” Cam straps have lower ratings.
For the trailer itself, see the open vs enclosed trailer guide. For the full loading steps that come before tie-down, see the loading guide. The snowmobile hauling guide covers the rest of the transport process.