Why move a sled on dollies
Dragging a sled across a garage floor wears the carbides, wear bars, and the track. Studs and edges can also gouge concrete. Placing the sled on dollies keeps the track off a cold, damp floor, and it takes some of the load off the suspension while the sled is parked. Putting a piece of cardboard under it does not stop the wear.
How much a snowmobile weighs
Typical sleds weigh about 450 to 750 lb. Heavier four-stroke utility sleds are at the top of that range. Two people are needed to steer a heavy sled on casters, especially on a slope.
Commercial dolly sets
A standard dolly set has three pieces:
- Two ski dollies. Cradles that hold each ski. A cleat or lip keeps the ski from sliding off. Check that the set fits your ski width, which is typically 6 to 7 in.
- One track dolly. It sits under the rear of the track. A typical track dolly is about 16 to 24 in square. Choose one wide enough for your track. Utility tracks that are 20 to 24 in wide need a wider dolly than 15 to 16 in trail tracks.
All three ride on swivel casters. Commercial sets are often rated around 1,000 to 1,500 lb in total, but ratings vary by brand. Check the label against your sled’s weight before you buy.
Lifting the sled onto the dollies
- Raise the rear with a sled lift or jack stands, then slide the track dolly under the track.
- Raise the front by the bumper or ski loops, and set the ski dollies under the skis.
- Never get under a sled that is supported only by a jack. Use stands.
Lifting a sled is a two-person job for most riders.
How to make a snowmobile dolly
A DIY cart can work, but the build is a bigger job than it looks. The main parts are:
- Deck. 3/4-inch plywood on a frame of 2x4 or 2x6 lumber.
- Casters. Four swivel casters, each rated well above its share of the load. A safety margin of at least 300 to 400 lb per caster is a common target.
- Wheels. Polyurethane or rubber casters, roughly 3 to 5 in across, roll over concrete cracks more easily than hard plastic. Hard plastic can crack and stall at expansion joints.
- Locking casters. These stop the cart from drifting on a sloped floor.
A full-length platform is roughly 4 ft wide by 9 to 11 ft long. That is a large build for most garages. Separate ski and track dollies are usually cheaper and take up less room. Check the rating of every caster and the deck before you load a sled onto a cart you built yourself.
Floor and garage tips
- Move the sled on a level floor where possible, or lock the casters.
- Use two people on any slope.
- Avoid expansion joints and cracks where you can.
- Keep the track clear of tools and debris before you move the sled.
Safety
- Use stands to hold the sled while you work underneath it.
- Keep hands and clothing clear of the track. Do not spin an exposed track on a stand, because it can throw debris and catch limbs.
When you move the sled out to a trailer or truck, the loading guide covers that step. For the wider transport picture, see the snowmobile hauling guide.