Open vs enclosed at a glance
- Open trailers are lighter, usually cheaper, and easy to load from the front or side. The sled is exposed to salt, slush, and debris.
- Enclosed trailers protect the sled and can be locked. They offer storage, but they are heavier, catch more wind, and use more fuel.
- Clamshell trailers have a hard, flip-up cover over an open deck. They sit between the two.
Open trailers
Open trailers come as tilt-bed, drive-on, or low-profile decks. A tilt bed tilts down to ground level so you can load without a separate ramp. See the loading guide for how that works.
An open trailer is usually lighter, which makes it easier to tow and store. The trade-off is exposure. Cover the sled for transport, and remove the windshield or use a trailerable cover for highway speeds. A regular storage cover can flap, tear, and chafe paint at speed.
Enclosed trailers
An enclosed trailer protects the sled and gives you lockable storage. The drawbacks are weight, wind drag, and fuel use. Snowmelt can pool inside, so look for a floor with drains and plan on venting the trailer.
Fuel vapors can build up inside an enclosed trailer. Vent it, and never smoke or run a heater with fuel odor present. Do not run a sled’s engine inside a closed trailer, because exhaust can cause carbon monoxide poisoning.
Inline or V-nose layout
- Inline trailers put the sleds nose to tail, usually with a drive-on, drive-off ramp door at the rear.
- V-nose trailers have a tapered front. That improves airflow and gives more room at the front for skis.
Size and sled fit
- Sleds are typically about 45 to 50 in wide and 10 to 12 ft long. Mountain sleds with longer tracks are longer still.
- Many trailers are built around 8.5 ft (102 in) wide. A deck around 101 in wide is enough for two sleds side by side. Check the interior dimensions, not just the outside width.
- A bigger trailer is harder to store, park at a trailhead, and tow. Buy for the number of sleds you actually haul.
Frame material and corrosion
- Aluminum resists corrosion and is lighter, but it costs more.
- Steel is cheaper and heavier. It rusts in road salt unless it is galvanized.
- Salt still attacks aluminum fasteners and wiring. Rinse the trailer after winter trips, whatever the frame is made of.
Deck features to look for
- Ski glides or slides for the skis, and traction strips or mats for the track. Aluminum decks in particular need both.
- D-rings or E-track for strap points.
- LED lights, a spare tire, and a drive-off front ramp on enclosed models.
- Roof vents and sealed floors on enclosed models.
Towing and brakes
- Match the trailer to your tow vehicle’s rating, and include the hitch. The loaded trailer weight sets what you need, not the sleds alone.
- Aim for tongue weight around 10 to 15% of the loaded trailer weight, with the sleds forward of the axle.
- Many states require brakes on trailers above a set weight, often somewhere between 1,500 and 3,000 lb. Check your state’s rule.
- An enclosed trailer that carries three or four sleds often needs a heavier tow vehicle, such as a three-quarter-ton truck. Confirm against the trailer’s rating and your vehicle’s tow rating.
Common misconceptions
- “Enclosed trailers keep sleds dry.” Snowmelt pools inside, so the floor needs drains and the trailer needs venting.
- “Bigger is always better.” An oversized trailer is harder to tow, store, and park.
- “Aluminum never corrodes.” Salt still attacks aluminum and steel fasteners and wiring.
Quick checklist
- Weight: the trailer’s rating, its empty weight, and your tow vehicle’s rating.
- Fit: interior width and length for the number of sleds you haul.
- Protection: an open deck with a cover, or an enclosed trailer.
- Deck: glides, traction, and enough tie-down points.
- Brakes and lights: check your state’s requirements.
Once you have a trailer, the tie-down guide covers how to strap the sled to it. The fuel guide covers gas before transport. For the full picture of hauling options, see the snowmobile hauling guide.