Short answer: squeeze, don’t jab
Use the throttle smoothly. Jabbing it causes jerky starts and track spin, and it makes the sled harder to control. Most modern sleds use a continuously variable transmission (CVT), so when you let off the throttle, the sled coasts rather than slowing like a car in gear. That makes the throttle your main speed control, and the brake is for stopping.
How the throttle works
On most sleds, the throttle is a thumb lever on the right handlebar. It is spring-loaded, so it returns to idle when you release it. Some riders use a finger throttle instead, which is an option on some sleds.
The clutch engages at roughly 3,500 to 4,500 rpm, depending on the model. Below that, the sled idles in place. Once the clutch engages, a smooth squeeze brings the sled forward.
Because a CVT gives little engine braking, the sled coasts when you let off. Expect a slow, gradual slowdown, not a sharp one. Riding the brake to slow down overheats components, so use the throttle to manage speed where you can.
Starting smoothly
- Warm up the engine for a few minutes, following the owner’s manual.
- Free a frozen track before you use the throttle. Rock the sled or lift the rear, then drop it. Forcing it can burn the belt.
- Check the throttle every ride. Squeeze it, then release. It should snap back to idle. In cold weather, ice can make it stick, so check before you go.
- Squeeze gradually. A gentle, steady squeeze gives you a smooth start.
Throttle by surface
- Powder. Keep a steady throttle so the sled stays on top of the snow. Too much throttle makes it trench and dig in.
- Ice and hard-packed trail. Use gentle throttle to avoid track spin and loss of control.
- Hills. Keep your momentum going up the climb, and don’t stop halfway up. Stopping on a climb can make it hard to start again.
- Steep descents. Control speed gently, and avoid hard braking, which can start a slide.
Throttle in turns
Ease off as you enter a turn, and roll on smoothly from the apex to the exit. Too much throttle in a turn can lift the inside ski. For how body position works with the throttle, see snowmobile turning techniques.
Brake and throttle
Avoid using the brake and throttle at the same time. Doing so can overheat the drive belt and the brakes. Use the throttle to manage speed and the brake to stop, and apply each one smoothly. For more on braking, see is snowmobiling safe.
Learning keys, limiters and youth sleds
- Learning keys and modes on some sleds limit speed or power for new riders. Features vary by brand, so check what your sled has.
- Youth sleds have adjustable throttle limiter screws. Set them low at first. See how old you have to be to snowmobile for age ratings.
The panic grip
A startled rider can grab the handlebars and squeeze the throttle wide open without meaning to. To guard against this, keep your hands relaxed on the bars, and know how to release the throttle, pull the tether, or hit the kill switch if needed.
Common misconceptions
- “Full throttle gets you unstuck.” It usually digs you in deeper.
- “Letting off slows you like a car.” A CVT sled coasts.
- “Thumb fatigue means you’re doing it wrong.” It’s common. Take breaks, or try a different throttle setup.
- “Riding the brake helps control.” It overheats components.
Safety
Always wear the tether. If the throttle sticks, hit the kill switch right away. For what to do after a fall, see what to do if you fall off a snowmobile. For the basic controls and pre-ride checks, see learning to ride a snowmobile.